APC Power-Saving Back-UPS Pro 900, 230V

APC Power-Saving Back-UPS Pro 900, 230V
APC Power-Saving Back-UPS Pro 900, 230V
Brand: APC
Product Code: BR900GI
Availability: In Stock
Price: [AMD] 141,000
Add to Compare

BR900GI Back-UPS Pro Features & Benefits

Battery and surge protected outlets
Back up and protect your hardware and data during power outages, surges and spikes.
Dataline surge protection
Provides protection of connected equipment from power surges on the data lines.
Surge only outlets
Protect secondary electronics from surges and spikes without reducing battery power used to run primary electronics during an outage.
Energy Management Function
Energy saving feature automatically power off peripherals when the a master device, usually a PC, hibernates or is shut down. Power to peripherals is immediately restored when the master device wakes up or is switched on.
Boost and Trim Automatic Voltage Regulation (AVR)
Gives higher application availability by correcting low and high voltage conditions without using the battery (not available on all models).
Green mode
Patent-pending operating mode that bypasses unused electrical components in good power conditions to achieve very high operating efficiency without sacrificing any protection.
Customizable voltage-transfer points
Adjust the voltage points (widen or tighten the range) where your UPS transfers to battery to maximize useful battery life and protect sensitive electronics.
Customizable voltage sensitivity
Toggle between pre-determined voltage-transfer points depending on your power quality (high, medium or low sensitivity), maximizing useful battery life and protecting sensitive electronics.
Intelligent battery management
Maximizes battery performance, life, and reliability through intelligent, precision charging.
Cold-start capable
Provides temporary battery power when the utility power is out.
Battery failure notification
Provides early-warning fault analysis on batteries enabling timely preventive maintenance
Automatic self-test
Periodic battery self-test ensures early detection of a battery that needs to be replaced.
Transformer-block spaced outlets
Protect equipment with input transformer blocks without blocking access to other receptacles.
Resettable circuit breaker
Easy recovery from overloads; no need to replace a fuse.
Simple battery replacement
Increases UPS availability by allowing quick, easy battery replacement.
USB connection
Use your PC to access additional power protection and management features for your UPS via a USB Port.
LCD Status Display
Provides key UPS status at a glance. Multiple status indicators with load and battery bar graphs.
Audible alarms
Provides notification of changing utility power and UPS power conditions
Disconnected battery notification
Warns when a battery is not available to provide backup power.
Safety-agency approved
Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.
Output Power Capacity 540 Watts / 900 VA
Topology Line Interactive
Waveform Type Stepped approximation to a sinewave
Output Connections (4) IEC 320 C13 (Battery Backup) IEC 320 C13 (4) IEC 320 C13 (Surge Protection) IEC 320 C13 (2) IEC Jumpers (Battery Backup)
Nominal Input Voltage 230V
Input Connections IEC-320 C14
Input voltage range for main operations 176 - 294V
Batteries & Runtime
Battery Type Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
Typical recharge time 8 hour(s)
Runtime for 100% load 4.6 (min)
Runtime for 75% load 8.4 (min)
Runtime for 50% load 16.3 (min)
Communications & Management
Interface Port(s) Optional Simple Signalling RS232 cable, USB
Control panel Multi-function LCD status and control console
Audible Alarm Alarm when on battery : distinctive low battery alarm : overload continuous tone alarm
What's included
Warranty 2 years repair or replace, 3 years repair or replace for European Union countries
Powered by Doxx Computer © 2014